![]() These imperfections of finish are not to be considered as product defects, but are characteristics the natural mineral finish. When applying it to the wall, place it in one of the bottom corners, and cover an area slightly larger than the brick. Place one layer on the wall, and one layer on the veneer brick. ![]() These deposit tend to lesson over time as the surface is washed by further exposure to rain. Learning how to do Venetian plaster walls in 3 steps is actually a lot easier than it sounds and if you follow through, you will be rewarded with a high-class look and feel of your room. Spread a 1/2-inch layer of mortar onto the back of the brick and the wall where its being installed with a trowel, and smooth the surface. To confer an increased degree of water repellency and compactness to the surface apply, after about 2/3 hours, with a steel trowel and pressing energetically, a layer of Cere D'Arte Wax or a layer of virgin beeswax.Exposure to persistent driving rain in the first few days after application, particularly to acid rain, can cause the formation of a whitish surface deposit due to the natural reaction of the calcium hydroxide that has not yet carbonised. At this point on the last layer, which has dried slightly, making sure that it is neither completely dry and nor excessively wet, proceed to the polishing by going over the surface repeatedly with a spatula, pressing hard. Apply one or two layers of Venetian Plaster Concrete Stucco with a steel trowel or spatula letting each layer dry before proceeding in order to obtain a perfectly smooth surface. Ensure that a sufficient quantity of the same batch of paint is available to complete the entire job, or at least to complete whole sections that will not reveal shade or application variances. Bespoke beauty Venetian plaster is the ultimate bespoke wall-surfacing product, as it can be customised to suit the style of your home. Scaffolding should be erected in a way that allows work to be continued uninterrupted until a natural boundary of the building is reached, to avoid seams, overlaps and differences in shade. Protect treated surfaces from rain for the time required to allow product to fully cure. ![]() Do not apply product if rain is likely or in the presence of strong sunlight, strong wind. Apply in temperatures between 8-30☌ and relative humidity below 75%. ![]()
0 Comments
Leave a Reply. |